sphyer

Hello Matt, Many thanks for your reply. I don't mean to sound silly, but would you mind help further please. Here's what I have done: PC#1(Host) ------------- Anykeeper card installed on PC#1(Host). Installed Anykeepr 2016 software on PC#1, run it, setup cameras & view ok. Goto setup within Anykeeper 2016, set user as "ANYKEEPER 2016" & password, goto USER tab & MODIFY the user account as ALL access. Let Anykeeper software running on PC#1(Host). Pls Note: TCP 8013 open, this is also port forwarded on DSL router to Host PC#1. Have tried port 80 too, same thing - same problem. PC#2(Remote/Client) ------------------------- On PC#2(Client/Remote), COMMAND PROMPT, PING PC#1(Host) IP Address - The result was fine, got sent & received values. Open MS IE(WinXP Pro), type in http://xxx.xxx.xxx.xxx (Host IP Adress). But I got nothing?? "This page cannot be displayed" - error. Then I goto SECURITY setup and enable ACTIVE-X, but same result. 2nd Solution on PC#2(Remote/Client) ------------------------------------------- Installed Anykeeper Network software on PC#2(Client/Remote). Type in Host IP Address & port 8013 - But I keeping getting Connecting to host, then host can not be found on STATUS (at the bottom). This where I got to. From your replies on other threads too regarding Anykeeper card - you said additional "Remote Access" software is not required. So everything I need to get remote IE viewing to work is here, but I don't know what I have done wrong. Would you mind help me get sorted on this please? Thank you very much

Could some1 PLEASE clarify this once for all for all new comer using Anykeeper 2016 DVR card. To use the remote IE view feature, what softwares, port forward, are required to get started using this feature pls? Thank you very much.

ok many thanks.

Anybody?? Pls I still need help on getting Anykeeper to run in Remote IE viewing mode? Anybody using the same card or software, pls advise. Thank you very much.

Hi, Can some1 pls help me get started on this feature? I have read most of the guide on this forum, and tried the following. I'm running a router with NAT enabled, so I port forward port 80 both within & outside the DHCP server IP addr to the PC with the DVR card installed, run AnyKeeper Network DVR System software and type in the local IP addr (DVR located), but on status=can not find host...?? I have tried and tried various setup and still same result. Could some1 pls share some light on this please, Thanks in advance Steve