Hey Guys and Girls...
I replaced the fan on an older PTZ this morning because it was running hot and smelled horrible. (it was still functioning normally though) Anyways, when I went to put it back up, it will not work....
It is a speed dome on a coax system. When it comes on, the fan turns on, and then it pans up as normal, goes around and the video shows up. Then it points straight down. Instead of coming back up, it just stops and the video goes out. After a few moments, it will go all the way up where you cannot see the Irus anymore, and it just pans right about an inch every approximately 30 seconds.
Any ideas?? Suggestions?? Advise???? Anything???
Thanks!!!!
