softtoptel

how much for the 300

Hi thanks for the reply ,yes i thought that might be the case shame as its a nice recorder ,the camera is a pelco ,what would i need sme sort of controller im not a wealthy man thanks

Hi i have a vista quantrum um4 dvr i dont seem to have any connections for my ptz camera i have 4 sensor sockets can i use these ,if not whats my options thanks

Hi i have a problem with my pelco ptz outside dome,when i first set it all up with my avtech dvr it worked fine then come the evening it just kept paning around and around so i lost total control of the fuctions i couldnt get into the menu while the camera was moving. the camera is new it has a heater built in ,i assumed as it got colder the heater kicked in and there was a power drain i was using a 24 vac supply as recomended ,i checked all the connections which seemed ok. i wondered if there is a reset sequence on the dip switchs inside the dome, i had used cat 5 twisted for power and video and control ,but tried power with 18g/2 wire but i still have no control any help would be much appreciated

Hi iv just tried a 12v power supply and the camera does the proper procedure but i have no control this could be because it need 24v ,and i get strange readings from 24v supply which i bought new from cctv dealer ..what do you think ?

Hi iv just tried what you said it just pans round and round no ups or downs ,i know what you mean by setup procedure its not doing that ...if i unplug it and repower it pans the other way. i used two wire on the plus and two on the right tnx

Hi thanks for answering..it states on manual its a excelptz range ptz300 six inch standerd dome . but has pelco stamped on it ,its 22x zoom . i used twisted pairs for data ,distamd about 30 ft from dvr which im using to control. i did test it all before i fixed dome to wall so it was very close to dvr .

hi i have a borsatec dsp 260x camera ,and i would like to be able to control the zoom ect via a remote , there are six wires leading from the camera unit red /black for power ,also brown/yellow /white/green. the camera works fine ,how and what could i use to operate the controls via the four remaining wires which i assume are control wires is my problem any idea,s would be much appreciated thanks