We have two types of elevators ones that go up only five floors those work fine. then there's the other ones that go up like 30 floors, these ones I have problems with. They are Otis elevators that and the cameras were installed previously. I just started here and no one has any info on the cams or who is in charge or what was ran. By what I can see though is there the regular corner mounts with I wanna say 24 gauge or 18 gauge wire that are crimped into a connector that snaps in the camera. 4 wires vid+ and vid- than the other two fro power. The problem is when the elevator is standing still perfect picture, but when they move very static picture until it stops again. the main box is hooked up by the elevator equipment all I have to do is get my mini max wire put ends on them and run the wire home. but even at the main elevator box when I hook up my monitor to it same static pic when it moves. is there any solution? I don't care throw out anything and a whole lot to try out please? The wires are pre crimped at the camera so I cant ground in there to anything. Should I run my feed back home on a Baulim maybe?
