Mecca22

We have two types of elevators ones that go up only five floors those work fine. then there's the other ones that go up like 30 floors, these ones I have problems with. They are Otis elevators that and the cameras were installed previously. I just started here and no one has any info on the cams or who is in charge or what was ran. By what I can see though is there the regular corner mounts with I wanna say 24 gauge or 18 gauge wire that are crimped into a connector that snaps in the camera. 4 wires vid+ and vid- than the other two fro power. The problem is when the elevator is standing still perfect picture, but when they move very static picture until it stops again. the main box is hooked up by the elevator equipment all I have to do is get my mini max wire put ends on them and run the wire home. but even at the main elevator box when I hook up my monitor to it same static pic when it moves. is there any solution? I don't care throw out anything and a whole lot to try out please? The wires are pre crimped at the camera so I cant ground in there to anything. Should I run my feed back home on a Baulim maybe?

it is twisted pair all the way down. voltage is feed from the car gear room in the basement. the cameras are funny when we usually buy new cameras we get the connectors to hook them up to the monitor but these were installed like 10 years ago an never got the connector. its not something i can rig up either it look like a dip switch with the 4 wires coming out. the feed at the bottom in the gear room is noisy. and then from there the feed is sent home which is of course the same (noisy) I think im gonna try and find away to ground it in the elevator room to see if it does anything like Birdman advised. I hope thats all it is too.