LeonPhelps

Has anyone seen this problem before, I just upgraded my DS-7316HI-S after it rebooted my monitor port doesnt work anymore.

Right now its just on the vga port, I will try bnc later tonight.

Anyone have any expeirence with the symsafe, I currently have been using storesafes at all my stores, but im looking to try something different. Other than the IP cameras is there any benifit of me switching to symsafe. I also noticed that the symsafe is priced better than the storesafe. Also whats the diffence between symsafe and symsafe pro ?

Is there anyway to change them from 1024 ???? To something else ????

You can now do it with the latest firmware , you will also have to change the bwval.dat file in wavereader to refelct the new port.

I know that after upgrading the firmware that you have to reinstall the network or something like that. I had the sofware before but cant seem to find it now. Anyone know where I can get it or what its called ?

Hi all, I just found this wonderfull site. Wish I had found it sooner there is alot of great info here, although I have alot of reading to do. Anyways on to my problem. I have a Ge 4ch Storesafe (Model#: dvr-4a-40) which I tried to flash a while ago. Now when I boot up it says Storesafe advanced V4.11a, then it says ERROR: No hard disk found. I tried replacing it with a new drive (exact same model) but havent had any luck. Is there a way to fix this myself, or do I have to take it in for repairs ???? Thanks in Advance LP

Well if I could get into the dvr menu I could set it up, as I have done many times before. However the problem is that it was flashed with the wrong firmware. Therefore whenever I start the DVR it just says no hard drive even though the jumpers are set correctly.

No I didnt get the problem solved yet

Cant set up the network to access the ssi page

Does this unit have any remote software ???? And if so where can I get it ???

Yep its set to master.