cctvmann

the best way of cctv over the internet is get a static ip attached by your provider explain its for the cctv use on your premises and they should be able to alocate you a static ip address

would your internet supplier be able to change to static ip address

ive always liked the dm stufff but found it a right pain the software was on the hdd not the memory of the dvr, ive started moving to hik vision now because of the hasslle of the software on the dvr hdd where hikvision has the embedded software on the pcb chip and it has more useability

its probably setup from factory as pelco d 2400 address 1 try that as the setting in joystick and see how that goes.

is this any good http://www.ebay.co.uk/itm/like/111722615308?lpid=122&chn=ps&googleloc=9045491&poi=&campaignid=207297426&device=c&adgroupid=13585920426&rlsatarget=pla-142405615986&adtype=pla&crdt=0

hi there can you pm me details of your install requirements, dont just go with a pre boxed kit because the cameras will be cheaper general standard units, if you tell me by pm what you require to see i can give you some guidance on which cameras would be better suited.

try changing the cameras and see if that sorts the problem out otherwise it could be a cable fault.

which model camera is it

your voltage is too low possibly because the resistance on cable run for dc power is too long or cable to small therefore resistance is dropping voltage once the additinsl night ir lights power pulls more current, can you mount the psu nearer the camera and feed from there.

can you upload a couple of pictures to this forum asi cant view the coded link you supplied thanks

http://www.cctvcentersl.es/upload/Manuales/RX210__(TRX228)_

http://www.cctvcentersl.es/upload/Manuales/RX210__(TRX228)_manual_eng.pdf ive found this if its any help

I gather this dvr must be to do with cakes as I get the impression the unit is scrambled

Any body able to advise on this brand of dvr

Sorry but I'm not on Facebook at all I don't use it