jkunesh

How do I get a PTZ to go to a preset associated with an alarm event in Lenel OnGuard platform?

no, the card reader interface receives the door contact signal at the door and sends it to the network over cat5. theorhetically the software should be able to send the command to move to the camera and get it done. I am not real familiar with the Lenel OnGuard software and this project was kind of "thrown" at me.....luckily, we do have a demo system here for me to test with before I go out to the customer site.

ptz control is via pc.....they use the mouse.

a door contact creates an alarm condition in the Lenel OnGuard software. Thus, theoretically, I should be able to tell the software somehow to send the PTZ to a preset when the door is in alarm. This is a completely IP based system. There are pelco spectra domes encoded through Axis M7001 encoders. There are also Axis Q6032-E ptzs on site. Not sure how to make this happen.

customer has many PTZ cameras and many exterior doors (all of which have dps on them). They would like to have a PTZ, for example, have several presets assigned to it associated with the doors within it's field of view. Upon a door opening (during certain hours) they would like to have the PTZ swing around and zoom in on the door that had opened. And eventually, down the road...., have the video sent to a dedicated monitor.

cameras pelco spectra series (2, 3, or 4...depnding on location) encoded by an Axis M7001 and also have Axis Q6032-E cameras on site. VMS is Lenel OnGuard.

Surely there must be a way to have the software automatically direct the PTZ to a preset upon an incoming alarm?

I am unable to get the T8310 to work with the Lenel OnGuard software...any tips?

Any tips for making this controller work with Lenel's OnGuard software?