Six9siX-Joe

left cam ok but right one little fogy Same type of camera If you know how to fix it it's a easy fix. Problem was the ir light find the way to the lens internally You can fix this with a rubber o ring to isolate the lens. Is it like this or worse? Is yours like bullet type camera? Try to unscrew the front ring of the cam (with hand)

My DVR Hikvision support only sata 2 It applies only to wd drives. So if a hard drive is sata 3 it can be downgraded to sata 2 with simple jumper Like this. Pic is from a pc.

My tv is also LG 42pj350 so for native res 1024x768 I have to select "PC" in the tv menu vga/hdmi.

Try this http://www.hikvision.com/en/download.asp?navid=0

AC-4951-CGI AviCom-4951-CGI = cmos+ircut The purple board (40$)has an option to add a mic, it has a 4 wire connector V12vGA Bad picture at night.(in total darkness) The blue board (30$) it's a cheaper one but no audio option and a little better picture at night. At daylight the picture is like a CCD.

Try to change setup parameters on android. "Channel Config" / "Dvr" / "Camera x" Try to lover bitrate. On my phone (simbian) I have a black screen live view when my wifi is too overloaded

Here`s what I have two diferent board sold with the same name.

This is a simple cheap dome camera So when opened if looks like this (IR plate - red/black 2 wires) and (board red/black/yellow 3wires or 4 with audio) its easy just unplug the IR plate on the connector if it has one if not cut the two wires. IR plate: red-power black-ground board: red-power black-ground yellow-video if the cam has electrical IR cut filter (on IR plate has more than two wires) better not disabling it. Try to unscrew the body of the cam if has no visible screws.

Internal ir reflection problem (protective glass removed because is indoor mounted) Lens mount and board contact leaks light. (can be easy repaired) same camera normal vs bad ir

Here's the pics

There is a pic. Here's another pic Normal and very bright

On a sunny day there is a lot of (street reflection)white in the camera view. Does this "white" affects the camera sensor or not hikvision DS-2CC572P-M

It is possible disable DHCP Write an ip address for the dvr First set up dvr then pc IVMS-4000 when this two work ok set up Your mobile (I have a symbian phone)

In the post above is how to turn off/on audio warnings. I have DS-7204HVIST/SE & DS-7208HVIST/SE On first boot (camera/vga monitor connected no HDD ) I have the same annoying beep Both of them take a few seconds to boot up and start recording. When I have a faulty HDD it takes time (about a minute) to boot up but no recording at all. Try to connect vga or bnc monitor/tv for the first time.

Go to -Main menu --System configuration ---Exception configuration Exception type: ALL (or what U prefer) Actions: uncheck all Save Sound Audio Warning is the main reason for beeping