dechowireless

Are you in Houston, TX? I'll get it installed for you and you don't have to lift a finger! Haha

Negative roger

Meye

Ive tried everything to solve this problem.. no dice anyone have any suggestions? i really don't want to send this back

There has to be someone who can help!?

Help I need a super password can anyone give me a pass for today or tomorrow thank you very much

Thanks guys for all your help

Can some generate me a password for today 9-27-13 thanks

What type of RG59 are you using? Extracted from Videcon SDI camera brochure Important - Please Note For HD-SDI installations, we recommend that this device is used with RG59 cable, with an inner conductor made of bare copper, with a minimum diameter of 0.7mm. Using a copper clad cable, or one with a smaller inner conductor, is very likely to reduce cable lengths or cause signal loss. Using the recommended cable should ensure that cable lengths of 100 metres can be achieved. thanks!!

still have the problem.. im going to change out the dvr tomorrow and see if it fixes the problem thanks for your help!

The original cable that is there is rg6 I ran a couple rg59 but I see the problem on a majority of the cams the distances are not that far also I have 2 power boxes...

I lowered it from 4k to 2k should I go lower? I dropped the resolutions from 1080 to 720 and the FPS from 15 to 13

Hello i have a DVR1604HD-L and i have installed all 16 HDSDI cameras to it everything works correctly but from time to time certain cameras would blink out for like 2 secs. I wonder is its the power so i went to buy a brand new power supply box each one of these cameras without IR take up 300mA with IR on it takes 900mA i have 2 power box one is 10A 9CH and the other is 18CH 11A the 10A is a off brand power box and the 11A is an ALtronix SAV1820. i dont think the power is the issue but i could be wrong... there are 6 cameras going into the 9CH box and 10 cameras going into the 18CH box... i calculated all the power ratios and its all correct. Now i wonder if its the compression of the DVR.. i dropped all the videos down to 720P @ 14fps and now i only get 2 cameras that blink... please help if you ever encountered this problem... thanks

Hello i have a DVR1604HD-L and i have installed all 16 HDSDI cameras to it everything works correctly but from time to time certain cameras would blink out for like 2 secs. I wonder is its the power so i went to buy a brand new power supply box each one of these cameras without IR take up 300mA with IR on it takes 900mA i have 2 power box one is 10A 9CH and the other is 18CH 11A the 10A is a off brand power box and the 11A is an ALtronix SAV1820. i dont think the power is the issue but i could be wrong... there are 6 cameras going into the 9CH box and 10 cameras going into the 18CH box... i calculated all the power ratios and its all correct. Now i wonder if its the compression of the DVR.. i dropped all the videos down to 720P @ 14fps and now i only get 2 cameras that blink... please help if you ever encountered this problem... thanks

Anyone? I'm stumped.