bentech

Hi Which protocol to use and which one to use for port forwarding on the router ? Tks ! TCP 4000 UDP 4001 HTTP 80 RTSP 554 Tks !

Tks for your response. There are 4 differents port , what is the purpose of each ones ? TCP 4000 UDP 4001 HTTP 80 RTSP 554

Hi having a Watchnet E-96032RTSH DVR and I want to update the CAM . What would be the best ones to fit with this DVR ? Is 700TVL the max ? Tks !

Hi , how to set the HOMING position for a BOSCH Serie 600 Analog PTZ camera ? Tks !

ok , tks ! Let s say I move the cam to the orientation that I want as HOME POSITION , what is the command to use to save it ?

RS485 should work also ?

Tks ! How to do these commands without a keyboard installed ? Can I use the DVR ?

Is there any presets ? I don't see where to set the HOME Position . Thanks !

This is the message what I see:

Hi , having a Bosch VDN-495V03-20 Dome cam that when connected, showing a message "upgrade in progress". How can I reset this cam ? TKs !

Tks... Can I do these commands from the DVR ? I don't have a joystick

Hum , I thought there was a better way

Hi , Having a Hikvision DVR ds-7332hwi-sh that cannot control the PTZ cam. The cam is a PTZ BOSCH serie 600. I attached a few pics with the settings. I don't have a keyboard , can I change settings without it ? Tks !

Are you in located in Canada or US ? They use the PTZ as a fixed cam , I just want to move it a bit to the right. Is there any way to do this directly to the cam ?

Hi , I would like to transmit wireless CCTV signal ~1000' from the source to a DVR/NVR or a regular display. I have 12V at the source and an analog cam but I can change it to an IP if required. Any idea if possible and waht I need to do this ? Tks....

Hi , having an analog camera over baluns (cat 5) with rolling horizontal bars. Having a PELCO GIT100 that help a lot but still having a few lines. Any idea of what can be done

OK tks... Is it possible that the signal is not strong enough ?

Here is a pic.... Having other cams with same baluns and working good. I swapped them to make sure..

arrow just showing rolling way

Hi , What is the standard pins that PoE uses regarding the IP cams? Is it pin 4-5 for positive and 7-8 for negative ? (48v) I want to test some IP cams and want to put power to them with RJ45

Ok , tks ! So anything to set into the CAM settings ? Only the NVR ?

Hi , A system is already installed but I want to confirm the recording settings to see if it's recording 24/24 or with motion. NVR is DS-7716NI and IP Cams are DS-2CD27x2F Do I need to set this up under the NVR settings or under the IP Cams ? I want to record with motion only. Tks !

Hi , Having a DIGIMERGE DHU600 that I want to connect to the Network. RTSP port is 554 WEB port is 80 PS: By the way , is RTSP external access port and 80 is on same network ? Do I use PORT FORWARDING settings on the router or VIRTUAL SERVER Do I open only 554 ? Tks !

Yes I know but do I forward it under VIRTUAL SERVER Setting or Port forward rules >

If I want to see only the video from the web , what port do I open and where ? Port forwarding or under virtual server ?