frazzeld

Adjusted the AGC (Higher) too much noise.....changed DNR to High still noise but a little improved Brightness didn't seem to make any differance

Shutter speed adjustment = Darker image So I have just adjusted one of my camera's shutter speed from Auto to 1/240 this setting has given me the desired effect that i wanted with regards to motion blur (vehicles passing by etc) however it has made the image slightly darker.. My question is do i now need to adjust the AGC to compensate and bring a bit of brightness back into the image? and do I go higher or lower? My current settings AGC: 12 Brightness: 11 Sense Up: 2 Daylight: Ext / Delay: 2 Smart IR: 2 IR: On Thanks

I now assume you are supposed to cut back the foil beyond the connection..... "No signal" when i left it on! cut it back perfect!

Bought some new cable so that I am ready for when I upgrade my system to HD SDI Do I need to remove the foil before I crimp the BNC connector Thanks

Thanks for the advise......I have CCS... but not on all camera's some have the cheap pre made cables, so i need to install fresh cable anyway...had around 80m of CCS on a roll, I will get some full copper core Thanks again

I will be upgrading my system in a couple of weeks...Analogue to HD-SDI My question, will the RG59 CCS coax be ok? max 25m run Thanks

if I upgrade my DVR from D1 to 960H will I notice the differance? cleaner image perhaps? a little more crisp on the edges etc Thanks for your help

Thanks for the response's I've set sens up to off Tried 3D-DNR to off.... made the image a little to grainy Currently got it set at Low, just need someone to walk passed (fast)

Hi All, looking for a bit of advise I've upgraded a couple of my camera's to Twilight Pro Nero - True Day & Night ICR, they have excellent day & night images however i do have a niggle with the night vision... one of the camera's is focused on my car which shows a good image now the niggle is occasionally when someone walks passed they appear to ghost and if they are walking fast they may even disappear The camera has lots of settings I've tried the following settings which didn't seem to improve the issue Sense Up: both Auto and Off Backlight: D-WDR set to 0 3D-DNR: Changed from Auto to Mid Looking for recommendations Thanks