andscheptev

As far as I know, nobody's figured out how to use the TFTP setup to unbrick a Dahua camera. Their tech support people can do it, but nobody's had much luck getting anything out of them either. Be sure to keep us posted on your progress! Yo! Check it out! If it becomes well documented, and it works, this guy's a hero... http://www.cam-it.org/index.php?topic=6510 Yes this method works. With some difficulty, but I also restored my dead camera IPC HFW2100. The myth about the invincibility of the DAHUA destroyed!!!

Yo! Check it out! If it becomes well documented, and it works, this guy's a hero... http://www.cam-it.org/index.php?topic=6510 Yes this method works. With some difficulty, but I also restored my dead camera IPC HFW2100. The myth about the invincibility of the DAHUA destroyed!!!

Hello everyone. My IPC HFW2100P after updating the firmware is bricked. The Putty terminal via an RS232 see this picture: Checking DDR......OK UBL Version: 1.43t(DM368 30/5/2012) Oscillator: 24MHZ ARM Rate: 270 MHZ DDR Rate: 216 MHZ BootMode: SPI Starting SPI Memory Copy... DONE U-Boot 1.3.6 (jerry) (May 30 2012 - 11:05:27) DRAM: 128 MB SF: Got idcode 01 20 18 SF: Detected S25FL128P with page size 256, total 16 MB In: serial Out: serial Err: serial Ethernet PHY: GENERIC @ 0x05,id:221513 total gio 2 gio[22]=1 gio[25]=1 Loading... TFTP from server 192.168.254.254; our IP address is 192.168.1.108; sending through gateway 192.168.1.1 Filename 'upgrade_info_7db780a713a4.txt'. Load address: 0x80100000 Loading: WARN: emac_send_packet: No link Retry count exceeded. Failed to get info.txt ==>use default images ## Booting kernel from Legacy Image at 80800000 ... Image Name: Linux-2.6.18_pro500-davinci_evm- Image Type: ARM Linux Kernel Image (uncompressed) Data Size: 1938236 Bytes = 1.8 MB Load Address: 80008000 Entry Point: 80008000 Verifying Checksum ... OK Loading Kernel Image ... OK OK Starting kernel ... Uncompressing Linux............................................................................................................................... done, booting the kernel. # Or such after entering DEBUG STATE: Checking DDR......OK UBL Version: 1.43t(DM368 30/5/2012) Oscillator: 24MHZ ARM Rate: 270 MHZ DDR Rate: 216 MHZ BootMode: SPI Starting SPI Memory Copy... DONE U-Boot 1.3.6 (jerry) (May 30 2012 - 11:05:27) DRAM: 128 MB SF: Got idcode 01 20 18 SF: Detected S25FL128P with page size 256, total 16 MB In: serial Out: serial Err: serial Ethernet PHY: GENERIC @ 0x05,id:221513 total gio 2 gio[22]=1 gio[25]=1 Loading...DHBOOT# BOOT# BOOT# BOOT# BOOT# BOOT# BOOT# **************** Unknown command 'BOOT#' - try 'help' DHBOOT# Сommands described in [http://www.sendspace.com/file/6i3m28] not met ... Tell me, please, what to do next?