dmaj123

To those of you that offered suggestions: QSEE support had tried to assist me thru at least 25 emails and 3 telephone calls with 2 calls FROM their techs. The email from tech support two days ago told me of a firmware update dated 5/28/2014 and gave me link and instructions on updating. I downloaded and installed according to their instructions. It took about 15 minutes for system to reboot completely. All of my settings were retained when done. The next morning I checked with my android at work. The DVR is NOW working as I expected. Tech support had told me that they could not get me going. Then an email and firmware fixed my problem. Thanks to all and Especially To QT Techs.

the techs at QSee walked me thru every setting after I sent them ALL information they ask for plus a lot they did not want. the only I cannot change is my internet service which is WIFI from local tower. I do not have cable available unless I cough up a little over $10,000 to run it less than 1 mile. this won't happen.

well unfortunately QT technicians' were unable to find out either. the ports are open and they were able to check them as correct. they walked me thru every setting on my phone and last communication said no more ideas. my isp said they do not block ports either but did say I may have to have static address even tho my ip address has been the same last 3 years according to checking by canyouseeme.org.

well, I have tried everything listed so far...even set up and set ddns with port forwarding to DynDnsstill no success..went back and reset defaults on QSEE SOFTWARE..still unable to connect...SERVER not found...any more suggestions?

So far I have tried everything listed...I CAN login and view from within home network on my Samsung Galaxy 3..I cannot login and view either home QT system or QT See dns website with my login thru QT Viewer..I also cannot connect to my IP address from outside..I am guessing this is a router problem but cannot find anything else to change...Even router firewall is turned off.. Any more ideas ???

tried settings posted last night to no avail..when I ented myq-see address, do I enter http also...I have tried entering my actual IP address withoud the port 80 or 81 and added 1723 instead. On myq-see.com I tried 1723 AFTER a colon but still no success..I have not tried a laptop outside of my home at this time. Sorry I do not understand all of this..Thank you for your help..

Please help!. Unable to view live from remote..Cannot connect because server not found ( if outside home network..) Qt See http port 81 Server port 1723 Obtain Ip Address Automatically is checked Local IP address 192.168.002.004 Gateway and Prefered 192.168.002.001 Alternate DNS is blank TEST shows ok SERVER: server 192.168.002.004 Server Port 1723 Device ID 382 Other Settings: ddns type myq-see.com User name (my email address) Password ***** Host domain: ****.myq-see.com TEST OK Using Belkin Router Ports 81 and 1723 Both show open according to IP address tester Entered IP address from whatsmyip. ***.***.***.***:81 Cannot log in to ****.myq-see.com or my home network from anywhere outside my network with my Samsung galaxy S3 with correct software..CAN remote view with Samsung within home network.. What am I missing.