buba

No, Im not, but tell me what step have you done so far ?

Thanks, i got it working and can view it over internet through dyndns.com.

you can go to cctvfactory.c and download it under model dvr8004. I got it going but i have trouble to setup to view over the internet, i did evrything that network manual show but could not view it, let me know if you get it working. good luck

This is the first step of Network setup manual that i have to do first before i can view it over the internet. Thanks Operation Instructions Please build an area network by connecting your DVR and your PC/NB with a network cable. Then, log in your DVR with the supplied AP software for the following settings. NOTE: Your NB/PC and DVR must be under the same domain to build an area network. Please change the IP address of your PC/NB into 192.168.1.X (X can be the number between 1~255, except 10) for login. The default IP address for your DVR is 192.168.1.10, and the default account/password are admin/admin. Press “SYSTEM CONFIGâ€

could it be something wrong with the DVR internal network card? or the default IP address is different than it told in the manual? how can i check the default IP address? the DVR is recording and viewing ok except the network.

I did what you instructed me, but its not working, its a AVTECH DVR-760 stand alone system,. Thanks

Do i have to use th Switch or Router? Thanks

I used the HUB, the default DVRs IP is 192.168.1.10 ( according the manual ) and i set my Pc is 192.168.1.11 . Tried log in using AP software provided with default password and port 80, nothing happen, ping 192.168.1.10 (DVR) , request time out. Help please!

Thanks, ill get the switch and try it, the DVR has the default IP adress according the manual. I'll post the result, thanks again

Hi all, I am a newbie , i just bought the AVTECH stand alone dvr http://www.avtech.com.tw/english/product_13_760.htm it works fine, iam trying to setup the network but iam not good in computer networking, the instruction said : build an area network by connecting DVR to PC with a network cable, then log in DVR with the supplied AP software to configure the DVR, (AP software is installed in my PC) I used the RJ45 cable connect directly from my PC to DVR and tried to log in DVR using AP software provided, but it failed. Please help! Thanks in advance.