kspksp69

Dear all Which module do I need to connect to my Geovision to use the alarm detection and transfert with SMS and GSM Call of the system ? I have understood that a Telit 862 can be used but there is many 862 type module and I cannot find the correct one .... Best wishes

The problem is that if the phone line is destroyed I will not be alble to send email, I then prefer to have a GSM modem, then which one could I use to have a good compatibility with the geovision all the best

I am in France and we have ADSL2+ which is in my case 8Mbps download and 0.8 to 1Mbps upload tested on my connexion. I have the configuration of 16 cam at 640x480 and the problem is that if I have just one cam on the screen there is about 7 FPS at 100 kbps but if I use the 16 cam I go down 0.7 FPS per cam because the rate is always the same at 100 kbps total......then I don't really understand why the system don't use 500 kbps to send more frame... Thanks

Dear all I have a Geovision 1480 + 8.1 software + 16 cams and the system is running OK onsite but when I use webcam module from my home I cannot have more than 100 kbps (I remove the speed limit on the server) and I have one PTZ (Pelco) which is running OK onsite and no connection from my home, the ports are open, the popup concerning the PTZ appears but nothing else... Hope somebody can help me... Best wishes

I don't think this is the upload possibility because since the beginning (about 6 months), this is the same speed limit, I have not seen any higher speed then I think this is a software limitation but I don't see were... Thanks

Which network setup ypu want to know ? This is an XP Pro system, ADSL connected with 1Mbps possible upload, there is a Bintec router, the XP firewall is OFF and all the incoming connexions are forwarded to the PC through the Bintec....