Jump to content

quak58

Members
  • Content Count

    1
  • Joined

  • Last visited

Community Reputation

0 Neutral
  1. Hi, I recently flashed 3.0.10 firmware onto the device and noticed that it has bricked it. Got the firmware from Hikvision global website version. File: Baseline Firmware_NVR (76NI-SE)_En_V3.0.10 141125 Before this I was running V2.3.10. The device now goes through the following: - Power up (power light green) - Double Beep - Hikvision NVR Splashscreen - Flashy rx/tx light - Flashy status light - Dead (no leds expect power on the front, and display signal dies too) All this while I was running a continuous ping on the device. It responds around the splash screen and then dies around the same time as the display. I was hoping if there is anyway I can restore it back to the previous firmware or perhaps fix this? Please advise.
×