vbob

Can anyone advise whom can provide password reset for Hikvision Cameras? I believe CBX does but am looking for verfication/contact and requirements for this. Thanks,

iTuneDVR, yes, TFTP does not require password and worked as expected. Afterwards, was the problem. Your reset work! Thank you very much!!

I did a TFTP firmware install and it would not accept my password or the password I had setup for the unit. (Not forgotten) Model: DS-2CD3332-I SN: DS-2CD3332-I20141213CCCH4XXXXXXXX Start Time: 2015-02-27 13:54:18 Thank you for any assistance you can provide.

Still appear to be locked out of the camera. Using TFTP, I am able to load messages but the last line in the message will read "date-time" Start file transmitting[C:\HIK\digicap.dav] I'm guessing it may be due to an incorrect firmware. previous lines show "Connect Client success" and then the "Start file transmitting" message multiple times. Camera shows in SADP with defaults and continues to reset to defaults when I attempt to change the I.P. address. Apologies on the multi submissions, still trying to figure this out and provide as much useful info for anyone who may be able to assist. Thanks,

Hello folks, I had a functioning turret on I.P. 192.168.1.250 under standard port 8000. I wanted to configure it to outside world viewable so I configured in the camera web interface to port 7400. Camera rebooted and has been non-viewable/non-connecting since then. I'm running POE and unpugged/plugged camera multiple times. Camera after approx 1 minute into startup shows on SADP with the network stats above. After a short bit, the camera disappears from SADP. During visable in SADP, I attempt to save the settings with the orginal port of 8000 but I continue to meet with configuration failed. As this camera does not have a visable reset, can anyone steer me in the right direction to gain access to it once again? Thanks to all

Ok, so it appears I'm a step closer to being up and running after using TFTP. I am now able to see the camera in SADP. The default IP info has been applied and the software appears to be allowing me to make modifications. I think I may be finding incorrect firmware though. If anyone can steer me in the right direction camera box is detailed as follow: SC2CD3332-I V5.2.3_141024 I ensured that I shut down TFTP, returned PC to network. Still unable to view camera but at least a step closer. Thanks for any info available.

Unfortunately, it appears that the IP 192.168.1.250:7400 remains unreachable. I tried connecting via the https as well and port 443. Still no ability to connect to device.