freebil

Hello. I have tried with both poe and ethernet+power from wall socket but I see lags. Every ~2secs the cars are stopping for <1sec and this continues. Is this normal? https://www.dropbox.com/s/cf9b3r3oha2gdhz/alarm_20150318_154028.mkv?dl=0 https://www.dropbox.com/s/g4tt8axefctfm1m/alarm_20150318_155516.mkv?dl=0 My settings are:

If you dont mind please check if your fi9828w has the port 65534 opened. Thanks again!

Thank you for your time.

Yes, the cat5e was connected directly to my router and it is the same I use every day with my pc and I have 1Gb link. With wall socket, I meaned the power adapter the camera came with.

I edited my previous post. Moreover, I have reset it from browser and from the button on camera many times. Thanks again.

Thanks for the answer. Here are the firmware: and these are the settings: I tried poe with cat6 cable and ethernet+wall socket with different cat5e cable. The cat5e was connected directly to my router and it is the same I use every day with my pc and I have 1Gb link.

Thanks for the answers. @TheUberOverLord 1.I have static ip address and I have set the dhcp range of router correctly. 2. I have upnp disabled. 3. I have wired connection(tried both ethernet+wall socket and poe). 4. I have set ftp server of the router disk, so the banwidth is 1gbps. Moreover, I have tested the disk can read/write 30MBytes/sec. 5. I dont have any problems with reboots. Today, I tried with different router. The results were the same. Yesterday I tried with ethernet and wall socket. So, the poe switch and the poe splitter are not the problem. Moreover, I downgrade to other versions of firmware and I upgraded to the last again. With all firmwares I had the same problem. I tried with ddns and only tcp connection. Again the same problem. I tried with different programs and different browsers. I port scanned the camera and I found that it has the port 65534 opened. Is it normal? Because, I read on internet that this port is for hack attack. Additionally, the foscam support said that the videos seemed normal. The only thing I did not try was wireless connection. The only thing I think is if the black cable of camera has problem, because I push it on installation. These are the ping times of the camera to my pc:

Thanks for the answer. I tried with 2Mbps rate and the video is much smoother. But if it has not enough power, why they release it? Can I see what proccessor it has? Tomorrow , I will try to connect wirelessly and/or with different router to exclude the possibility the fault to be in my network. I will post updates.