angelt

I am installing several american dynamic PTZs. I am able to get them on by plugging them into a jbox but I'm not sure how to get control of them. There is a cable that leads out of the jbox which I assume is what needs to be connected to something but I dont know what. I intend to use an ad2088 controller hooked up to megapower 3200 matrix switcher. Does anyone know where the cable from the jbox needs to go?

MaTrix switcher is megapower 3200

I think I have the matrix switcher also. And I have the little white box where it has 2 data cables coming out of it one is supposed to go to the controller and the other the system but I'm bot sure where I have 3 intellex dvrs nd then there are two boxes underneath with several Ethernet ports followed by a large box that has all the ptz outputs going in to it from the three dvrs

I am trying to setup a few PTZs they are american dynamic. I have a few intellex DVRs I am hooking them up to. I am able to get them to turn on and record on the DVR but I'm afraid my knowledge is limited and I can't get the control going. Im using a sensormatic ad2088 contoller. I figure the problem is the sensormatic transformer. How do I get the transformer to communicate with the controller or the DVR and in turn the controller. I haven't been able to get the controller to turn on either. I also have several checkpoint PTZs that I was able to set up is there a way to combine the systems so I only use the newer ad2088 controller? Any help would be appreciated.