Hello to everyone, Well, I'm neck deep into security cameras now but I'm learning as I go...
I have a question about the wiring of the pigtail on a mysterious 2.0MP IP Camera that I have, No Brand, No ID, and no picture either. It dose power up and do the home position cruise, but that's it.
The Ethernet F/ plug is wired differently than I have seen before. It has from left to right as follows:
blue/white
blue
green/white
green
Black
Red
so the pinout is: 1,2,3, 6, Gnd.
But after exposing the rest of the cable there are also red, purple, brown and black that is fused(soldered) to the brown wire.
The above wires red,purple,brown & black are not connected.
Any Ideas?
P.S. I have also tried using a crossover cable but it made no difference.
antiflow1