rebekic

As i mention in headline... Motion is detected, yellow alarm bell shows up, starts to record, but after a second yellow bell is gone and recording continues to whatever is set up (30sec) and then stops, even though people are still moving in the frame. The setup is: NVR: DS-7608NI-E1 / A (V3.4.98 build 171121) Cameras: 4 x Panasonic WV - SF-539 (have one Hikvision camera...works ok) Also additionl question: Hikvision camera that i have is DS-2CD2342WD-I (V5.5.82 build 190220). It has the option "line crossing", is there a possibility to count people who crossed the line back ad forward (a<->b - in - out) and alert me when certain number (set) are reached. I need this for my Airbnb rental. If this camera can not do it, any other suggestion for this system (i also have face detection on this camera enabled but i can not seem to use it)

Hi I have two question regarding my WV-SF539 cameras: 1. One of them (i have 6 other working perfectly) can not obtain IP address (only red light is blinking), all is working (my friend measured) but it look like software/bios is down...is there any way to upload bios to camera and there fore obtain IP address again 2. I want to use 3 of them outside , is there any cheaper solution (housing) that can fit with this cameras and also to be waterproof any help/advice would be welcomed