markc_uk

Hi Szymon. With this update, do you still have either HDMI and/or VGA outputs working? How did you finally install correctly? Thanks.

Updated my 6200-4e to the latest firmware but now I have lost video output on both HDMI and VGA. I've tried going back to 20150808 firmware with USB boot (which has installed fine), but again, no HDMI or VGA video outputs. Any ideas anyone?

Hi, Could anyone advise. I have a couple of Escam Qd-300WiFi and Escam nvr (N6200-4e). I finally got everything 'nearly' working (including email alerts with attachment following a Dec firmware update to the camera, supplied by Escam support). However, I still have an issue with motion detection, where recording will start OK (I see "motion start" on nvr log"), but it never stops recording until I manually force a stop. Escam support do reply from time to time, and did advise the WiFi variant only supports Onvif, where as the QD300 (non-Wifi) also supports I12 protocol. So it seems I need the QD300/I12 product for motion detection to fully work (i.e. start on motion, then end when motion stops). The nvr has a parameter that allows both pre and post record times to be set, which also appears to work fine. I guess there are two questions; 1. Can I load firmware of a Qd300 onto a Qd300WiFi and benefit from the I12 protocol? 2. Is there a way to add I12 protocol to Qd300WiFi? Failing that, I guess it's a case of buying a Qd300 and seeing what happens. Any thoughts? Mark.