Jump to content

wang_chung

Members
  • Content Count

    4
  • Joined

  • Last visited

Everything posted by wang_chung

  1. These are pre-made cables I am using, not ones I made. I'm still in the testing phase of this new camera. I believe they are stranded copper. 1. It's not the NVR as it won't acquire an IP when connected directly to the router or my computer set in the corresponding subnet. 2. I haven't had a chance yet to custom make my cables, this tests were preformed with store-bought cables that work fine between PC and router. I have tried both cross-over and straight cables, but I don't think it matters anymore. Thanks for the replies everyone!
  2. I got a 3MP wired IP camera that stopped working. I had it running for a couple days straight recording video on my NVR. I tested the power supply and it is outputting 12.4v, the cat5 that I ran is testing clean with no shorts between any of the wires (used a multimeter). The LED lights on my router and camera show it connected, but it doesn't bring up an IP. When I search for them with different camera software, I no longer see the static IP that it was programmed for (192.168.1.10/11), just a 127.0.0.11/12 IP with the correct serial number, but it doesn't work when I add it (can't connect). I can hear the IR cut filter flipping on/off, the camera doesn't smell "burnt", and there was no storm/lightning. I have swapped cat5's, power supply, plugged camera directly in to pc, checked continuity all the way to the circuit board thinking maybe the plug was bad. I have no idea why it may have failed, and don't want to buy any more camera's until I figure out (and fix) why it happened in the first place. Thanks in advance!
  3. ....I plugged my other working camera into the same cat5/power outlet and it stopped being acquiring an IP after 10 minutes. Could it be an intermittent short in the cat5? or an intermittent voltage spike in the power supply? or maybe firmware corruption? I have a USB-TTL converter on the way.
  4. I tested the power supply without the camera connected, no load, so Vo? Been a while since my electrical diagnostic class, sorry. The label on the power supply indicates it has more than enough mA's, and I tested the draw of the camera and it was within specs (spoke to the manufacturer). I did bring the camera next to my NVR and connected it with three different 4ft cat5 cables, both to my router and to my PC wit no change in condition. I did a bit of reading and found that my camera's network processor is the SMSC 8710a, and according to the following wiring schematic, I should have continuity between pin 28-31 (tx-,tx+,rx-,rx+) should be going to the RJ45 connector but I don't have continuity? Can anyone take a look to confirm? http://ww1.microchip.com/downloads/en/DeviceDoc/EVB8710%20Evaluation%20Board%20Schematic.pdf Thanks
×