I want to rebuild firmware for TVT DVR 2316ME.
Im using UARTO debug rs-232 connection.
Connection of COM settings seems to be fine:
Bits: 115200 / 8 / none / 1 / none
While reading log i can't hit break command - CTRL + C to abort. Tried in other terminals like putty etc. and other PC's. The effect is the same - system is starting continuously.
Any tips ?
Example log:
In: serial
Out: serial
Err: serial
close watch dog begin...............
dog_close
Ŕs˙ŕüdog_close
NAND: NAND_ECC_NONE selected by board driver. This is not recommended !!
128 MiB
no redund = -767506610, tmp crc -767506610
U-Boot 2008.10 (Nov 30 2011 - 16:23:28)
DRAM: 3 GB
Flash: 2 MB
gd->env_valid = 1
In: serial
Out: serial
Err: serial
close watch dog begin...............
dog_close
dog_close
current do_check_flash_boot_param
product type 49 === 1
*****+++++******* do_auto_update 201111301027
USB: scanning bus for devices... 1 USB Device(s) found
0 Storage Device(s) found
Press CTRL-C to abort autoboot in begin ... do_auto_logo_image
ntsc pal 1
logo img width 0, height 0, vga out = 8
jpeg decoding ...
<>
<>
decode success!!!!
start addr color = 0, logo img width 480, height 320
NAND read: device 0 offset 0x200000, size 0x100000
1048576 bytes read: OK
NAND read: device 0 offset 0x300000, size 0x200000
2097152 bytes read: OK
NAND read: device 0 offset 0x500000, size 0x300000
3145728 bytes read: OK
NAND read: device 0 offset 0x0, size 0x200000
2097152 bytes read: OK
## Booting kernel from Legacy Image at c1300000 ...
Image Name: hilinux
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 1529468 Bytes = 1.5 MB
Load Address: e2800000
Entry Point: e2800000
Loading Kernel Image ... OK
OK
Starting kernel ...
Uncompressing Linux................................................................................................. done, booting the kernel.
