jakazz

OK...I must be slightly retarded... i change the resolution under video source to 640x480... I tried regular and de-interlaced, and no change compared to 320... Am i doing something wrong? Do i need a better screen and/or video card? I'm using the crappy on-board VGA, with Dell LCD...probably not the best...but do i need to upgrade, or should i see a difference? Could it be cuz of the cameras?

i just installed GV1480 (16 camera) DVI. I installed 3 camera so far...so good. Only problem is when i go to Configure (F9), then click on Camera 1 Tab... the camera resolution is 320x240. HOw can i kick this up higher? Cuz the camera picture is good, but slightly grainy. I know the cameras are spec'd for about 500 or so pixels.

Well, i bought it from worldeyecam... their tech support VPN'd into my system, and they couldn't get it to detect either... so i sent it to them, they call me and says it work fine. So, i was frustrated at first, and told them to send back... i plug it in, and voila...it f$%#$ works...go figure. Dont know what they did to it, but workin now. THX all

1) I sent it back, and the company called, and left me a message saying it works fine by them... Should I trust them? 2) Secondly, no one told me where to look in the BIOS for the card. Can someone help me out there? 3) I had also tried the card on a different PC (but it was not a compatible chipset), it also did not detect. My understanding is that the chipset compatibility is because of tmimng issues, and such, so should any computer at least detect it??? Can someone please answer my 3 questions...Thanks in advance, I appreciate the help.

where in the BIOS would I see it? would it be dead eventhough the PW LED is lit on the card?

oh...i forgot to mention...i also installed the drivers from the Geovision CD...still nothing... And nothing showing in the Device Manager.

i built a new system as follows. -Intel Pentium? 4 631 Processor Cedarmill 3.0GHz, 800MHz FSB, Socket 775, 2MB Cache -ASUS P5GC-VM Intel Core 2 Duo (Desktop) Socket 775 1066MHz PC2-5400 (DDR2-667) mATX Motherboard -Corsair TWIN2X2048-5400C4 2GB DDR2-675 XMS2-5400 Xtreme Performance Memory -Windows XP-Media Center Edition -GV-1480 DVI type -----------so when i plugged the GV card in, and boot up, WinXP does not detect the card. when i open the PC case, I can see that the "PW LED" is lit opn the GV card..but the "FP LED" is not. I don't know what the FP stands for to be honest. I;m a newbie at CCTV, but I know computers pretty well...am i doing something stupid? did i forget something? ALso, there is a jumper on the GV card, do i need to do anything with that? Is my card defective?