Jump to content

terol

Members
 View Profile  See their activity

  • Content Count

    2

  • Joined

  • Last visited

Posts posted by terol

  1. Posted 

    a couple of days of experimentation and the correct settings for the programmer was found. I use T48 and Xgpro software.

1) the dump must contain a spare area (dump size 132MB)

2) set the settings in the program: 

bit flip permission: 1bit/512B

internal ECC: disable

spare area in the file: include spare area

And after the recorder has started, set the native serial number and MAC through the terminal

setenv ID my_serial

setenv ethaddr my_mac

saveenv

  2. Posted

    Dahua XVR5232AN-X -bad blocks appeared on flash. I tried to clone old flash  F50L1G41A to new one. But xvr stuck on message "System startup". 

    Then I flashed the factory flash XVR7x16-X (and a couple of others) - the result is the same.
In the program, when flashing the firmware, I tried to turn on and off the Spare area programming (I also cut out these areas from the dump). The result is the same - in the console there is only "System startup".
Does anyone know how to properly replace a flush in these regs?
×