TV Tony

Preset 64 worked! So I have to enter into this control program as 255 1 0 7 0 64. 7 being the CALL PRESET command. Now, The crosshair and camera number are removed and I would like to be able to send a command to the wiper without having to go into the OSD every time. Does anyone know this preset or command? Thank you.

Hello, you may want to try LED bulbs. The flicker rate on the bulbs could be pretty close to the frame rate of the cameras. Or the camera is to close to the light and getting some interference? Poor ground on the light maybe? Thank you very much for your reply. The lights are LEDs and the cameras are very much close to the lights. This is a small room ( 2*2m) and no other place to install the camera. Can u please explain what u mean my poor ground on the light. Possibly when the LED light fixtures were installed the ground wire was not totally secured. This may cause an issue with the lights that the camera is picking up. I'm simply brainstorming with this. It could very well be the cameras are just too close to the light. Maybe try some type of deflector (card board) on the light fixture to block the light from shining into the camera.

Hello, you may want to try LED bulbs. The flicker rate on the bulbs could be pretty close to the frame rate of the cameras. Or the camera is to close to the light and getting some interference? Poor ground on the light maybe?

We use a generic camera controller to send commands. It seems there is no way to hit any keys in sequence. Here is a screenshot of the controller. I have tried many of the OSD commands listed on the board and none seem to work. Check this out.

Hello, We currently added this M5 to our field camera set. We have 2 other DefendIR ED50 cameras. Those OSDs come right up. We use Windows based generic camera controller software. Pelco-D commands. After all that I've read on this board I should be able to use preset 95 to show the OSD. This preset works fine on the ED50s. That M5 though..... It has a crosshair and camera number on the display not to mention that the PTZ speeds are much to fast and need to be adjusted. When I send the preset 95 command to the camera the display only flashes the crosshair and does nothing else. I've also tried preset 85,90 and 91. All to no avail. I need to get into the OSD. Any advice would be appreciated. V/r, TV Tony