slats

thanh you; i should check the housing before posting

i have a plug in transformer that went bad,120vac in 16.5vac out 40va what voltage is required for camera and housing with fan and heater. is there a range? i thought that ac cameras were 12 or 24volt? any advice is welcome

nothing special,just trying to find some basic info as to what is a good system

thomas: what is the advantage of insight over geo

i started to look into geo vision and some one sugested i look at insight and linix systems

comments please,the good ,the bad ,the ugly on videoinsight

i think video insight has it,read there manual

i have iview 2.80, when i install current downloads,my computer will not stay connected to the internet for more then 10-15 minutes.if i revert to a early date and use 2.80 it stays connected,i am lost, any help or ideas that i can try thank you

c7 in ca :thank you, can you tell me where you searched?

off the box top;cc-4412/color sony 1/3" ccd dsp bullet night view cam 4.3mm w/12ir led...power dc12v ...camera ntsc f=4.3mm.. [item no:2b49].would like replacement to be a little wider view... thank you

the computer has 4 cards for i view=16 cameras when they record there is a time laps between clips, it might be anywere from 4 to 50 seconds.( i was going to try another computer,faster processor and more memory) i think the computer has a celeron in it.not sure.i defrag weekly and clear all clips 3-4 days. i am using xp.

vst-man; the dealer was aware of all the problems allalong,my point is i think in this case and this application the dealer screwed up and did not want to resolve it or did not know how to,at a minimum he should have known that the computer was to small to handle 16 cameras. hell he is in the bussiness. after reading this board i fell i can do it better. money was not in question in this application,in fact i said i would rather pay more to use a local dealer.also i think the dealer was shooting from the hip and was somewhat new to video. i am not mad at him, but will be hard pressed to do another system with him

i bought a 16 camera i view from a local dealer,because if i had a problem i can go to him. right,,....well what i learned was that the computer is too small, i can not get the current updates to work, and i am not so sure they know that much more then me about video security. so now i want to do another location why should i bother with a local dealer when i will have to fix it myself????

i have a i-view 16 camera system that comes on after a power failure

i have a 16 camera i view system,when i review video clips there is a loss of time anywhere between 4 to 64 seconds between clips. anything i can do?