slats

thanh you; i should check the housing before posting

i have a plug in transformer that went bad,120vac in 16.5vac out 40va what voltage is required for camera and housing with fan and heater. is there a range? i thought that ac cameras were 12 or 24volt? any advice is welcome

comments please,the good ,the bad ,the ugly on videoinsight

nothing special,just trying to find some basic info as to what is a good system

thomas: what is the advantage of insight over geo

i started to look into geo vision and some one sugested i look at insight and linix systems

i think video insight has it,read there manual

i have iview 2.80, when i install current downloads,my computer will not stay connected to the internet for more then 10-15 minutes.if i revert to a early date and use 2.80 it stays connected,i am lost, any help or ideas that i can try thank you

off the box top;cc-4412/color sony 1/3" ccd dsp bullet night view cam 4.3mm w/12ir led...power dc12v ...camera ntsc f=4.3mm.. [item no:2b49].would like replacement to be a little wider view... thank you

c7 in ca :thank you, can you tell me where you searched?

the computer has 4 cards for i view=16 cameras when they record there is a time laps between clips, it might be anywere from 4 to 50 seconds.( i was going to try another computer,faster processor and more memory) i think the computer has a celeron in it.not sure.i defrag weekly and clear all clips 3-4 days. i am using xp.

vst-man; the dealer was aware of all the problems allalong,my point is i think in this case and this application the dealer screwed up and did not want to resolve it or did not know how to,at a minimum he should have known that the computer was to small to handle 16 cameras. hell he is in the bussiness. after reading this board i fell i can do it better. money was not in question in this application,in fact i said i would rather pay more to use a local dealer.also i think the dealer was shooting from the hip and was somewhat new to video. i am not mad at him, but will be hard pressed to do another system with him

i bought a 16 camera i view from a local dealer,because if i had a problem i can go to him. right,,....well what i learned was that the computer is too small, i can not get the current updates to work, and i am not so sure they know that much more then me about video security. so now i want to do another location why should i bother with a local dealer when i will have to fix it myself????

i have a i-view 16 camera system that comes on after a power failure

i have a 16 camera i view system,when i review video clips there is a loss of time anywhere between 4 to 64 seconds between clips. anything i can do?