radman

Yes it does all still working fine I just wish the recorded video was better quality

I think I have solved my problem I removed all the previous drivers and installed the v8.3 again this time it said upgrading hardware from 1.42 to 1.55 rebooted and now it has been running for 2 hours Sorry just noticed Tracker I am using a GV-1240 D type 16.

I downloaded 8.3 from Geovision they gave me the link after verifying my details, I installed it ran for about an hour then said my card may be counterfeit and duly shut down No way is this a dodgy card it has been running since 2007 on 8.1.2.0 and 8.2! I restarted the software and it has now been running for over an hour! I have reported the fault to Geovision it will be interesting to see what they say? It happened again so back to 8.2 until I get some info from Geovision

I received an email this morning saying it was released on the 2nd Feb! I have sent a reply so wait and see time

I have filled in the registration again James still no link to the download Sorted thanks James

Hi James thanks for the reply I did try Geovision but they just came back with a list the card will support not very helpful. The only solution I could think of was another GV-Net card and use Com1 or anyother apart from the one I am already using! then run the JVC software on it's own? Thanks, John.

Back again !! I have bought a JVC TK-C1480BE which has RS485 set up inc digital zoom, is there anyway I can run the camera through the Geo software? there is a setup program I down loaded! if I am using Com3 for my GV-Net card I have no serial port on this new Intel board other wise I could use Com1 loads of USB's! is the answer to get another Gv-Net card? if I cant run it on the present setup Thanks, John.

No problem rory you learn one way or another I just appreciate the help and advice! John.

I tried again removing the software and folder plus the driver, re-installed the software and once again it came back with the old configurations. So I removed all again and went a bit deaper and there is a lot of files left in the windows folder I deleated them and reloaded the software and all is now well including DSP! Thanks to all for their help John.

Ok I uninstalled the software removed all I could find with RegCleaner reloaded the software it wasn't a clean install as the previous settings were reloaded password,cameras etc has this to be a total wipe of the Harddrive or is there information stored I can remove? Thanks, John.

Hi James I went from 7.05 GV-800 to the GV-1240 so I will give you suggestion a try, Thanks, John.

I am getting a bit confused the only reference to DSP I can find is when the Geo software is loading in the square box it says "Detecting DSP" then it disappears! where is Spot Monitor? as far a software goes rory I am running 8.12 and the card is legit and I have the latest DirectX 9 installed! "lost" Thanks, John.

Thanks matt I will investigate thanks for the info, John.

Back for more advice! on the card there is the video OP socket but pluging in a monitor there is no video, I have stuck a scope on it to make sure and there is none! Am I not doing something or am I loosing the plot

I got and understood all that Rory I will try a seperate Graphics card the on board is not bad but it uses the on board memory. The Iiyama is my PC monitor the cameras I am using are WV-CP484E and the results are good day and night I have a couple of dark spots which I will fill in with IR later. Thanks, John.