paprotec

I will double check, but last I knew Bosch were not using Kodicom's dome. Doesn't the Bosch do auto tacking on its own? Kodicom's does it with the DVR software.

Any one know of a good VDA. I need 8 in 16 out. Thanks

Yes, sorry.

that is good info to know. Do they have any US OEM's?

Anyone know the 3R DVR? Is it any good?

Argus under $1,000 I think

What version of software are you running? Do you have the IP? Send me a PM and i'll check your speed against what our test servers are running. We usually get good transfer rates with DigiFlower.

Unimo are also very good, but i don' think they have PoE. http://www.unimo.co.kr/eng/?tmpl=ProductMiddle&lNum=2&mNum=20 http://www.saysecurity.com/network.htm http://www.pixord.com/

SAY Security sells the Pixord IP camera with some special software to record over the network. Pixord do have PoE and are much less than Axis. Quality is good.

yes, they are still selling them

I don't think GS is doing it. I think BW is just telling everyone they are. GS is now doing a lot themselves.

GS is tt Big Wide. But they will be doing more and more on thier own. There is a lot more churning to come.

http://www.aegison.com/ Aegison is not bad, but expensive. We sell one that is less expensive and does 4ch of video 4ch of audio. Best i've found. www.saysecurity.com

yeah, not a bad board. Anytime

you got it

I believe this is the S 1000 board. Call Jim at dvrsupply.com He'll tell you for sure.

yes

www.vigilos.com What type of DVR they use? What they charge?

DX8000 is not the Kodicom board.

We've been using SATA in our DVR's for the last 3 months. Very nice! Have over 250 in the field with no problems.

GS and Sungin have been on the outs for some time. I don't think Pelco is using the Kodicom board. This would take a total rewrite of the drivers and software. Its possible because its still a capture board. Kodicom has over 50 OEM's, but I'm 99% sure Pelco is not one. Picasso always sucked. Too bad Pelco didn't see that sooner. How about CQ Max? GS should now shift to do everything themselves.

I'm bidding against them for a big bank chain. Anyone know what their average cost is? I know they have a good unit, but know I can beat them on cost. Anyone ever sell one?

One of my dealers is bidding against one of their dealers. Would you say more than 6K?

A GOOD consultant can save the EU 20 or 30k on a 100+ job. So that would be my target amount on a job that size. No less than 15k. Would you be specing the job?

Anyone doing Winnertec downunder? They are good. TOM is ok, but need software help. Problems with Eastern.