rdawg 0 Posted April 12, 2008 I have a sensormatic speedome 2000 ptz camera that needs fixed. Does anyone know where i can get it repaired besides Moore's electronics (They are outrageous) The problem is i have no control of the camera via the controller.. The camera's picture is fine and it goes through it's rotations but i can t control it. DOES ANYONE KNOW OF WHAT DEFECTIVE PART COULD CAUSE THIS PROBLEM??? tHANKS GUYS!!!! ps ANY WEBSITES OR HELP WOULD BE APPRECIATED Share this post Link to post Share on other sites
UMDRanger 0 Posted April 12, 2008 Have you tried different addresses? Made sure the +/- connections are correct? And can you see what the three LEDs on the PC board are showing and looked them up in the manual? It may be as simple as the wrong wire, or a damaged wire. Or the PC board may be bad, but since it boots and does the boot self test I'm inclined against a bad board. Share this post Link to post Share on other sites
Brenton81 0 Posted April 13, 2008 Make sure the jumpers on the Unicard are set correctly for whichever communications protocol (Sensornet or RS422) you're using. Share this post Link to post Share on other sites
