resqinc 0 Posted January 14, 2009 Does any one know if the Pan. 964 PTZ can use Pelco protocals? Also how do you access the area for changing the camera number and such? Thanks Share this post Link to post Share on other sites
Soundy 1 Posted January 14, 2009 Since none of the documents Panasonic has online list Pelco protocols, I would suspect not. It would require a serial connection, which it doesn't appear to have. The spec sheet has a diagram that shows an "I/O connector" but nothing specifies exactly what its purpose is. http://catalog2.panasonic.com/webapp/wcs/stores/servlet/ModelDetail?storeId=11201&catalogId=13051&itemId=207163&catGroupId=15568&surfModel=WV-NW964&displayTab=R Share this post Link to post Share on other sites
InNorthernWeTrust 0 Posted January 14, 2009 Yes it supports Pelco P protocal. Please visit the link below for instructions: ftp://ftp.panasonic.com/pub/Panasonic/cctv/FAQ/10.RS-485_Configuration.pdf Share this post Link to post Share on other sites
resqinc 0 Posted January 17, 2009 Thanks for the help Share this post Link to post Share on other sites
bike_rider 0 Posted January 22, 2009 Yes it supports Pelco P protocal. Please visit the link below for instructions:ftp://ftp.panasonic.com/pub/Panasonic/cctv/FAQ/10.RS-485_Configuration.pdf Thanks for the lead on this, but can you go into a little more detail? From the FAQ I get that the DIP switches are setup differently for the addressing, but I don't see anything else to change on the camera. Then the question is, what do you change in the GV software to complete the "conversion"? Share this post Link to post Share on other sites
InNorthernWeTrust 0 Posted January 23, 2009 Shouldn't have to change anything in the software. Just make sure to set the GV software so that the camera is being controlled by Pelco-P. I'm really not familar with the Geovision software though. I think others on the forum would know more. Share this post Link to post Share on other sites
bike_rider 0 Posted January 23, 2009 Thanks. I was thinking I was still over in the Geovision sub forum. Never mind. Share this post Link to post Share on other sites