Jump to content
Sign in to follow this  
shaunrbennett

Ancient CCTV equipment

Recommended Posts

I'm looking for help with some older CCTV equipment.

 

I compiled a bunch of replacement parts from ebay, they all came in new and never used.

 

WV7150D - Outdoor Camera Housing

WVCU254 - Controller

WVRC150 - Reciever

WV7260D - Pan/Tilt

WVCA50 - Pre wired cable for housing to pan tilt.

 

WVCL930 - Camera (new from panasonic distributor)

 

The picture comes in fine, but the controller doesn't seem to play well with the pan/tilt head...the pan/tilt head moves in all directions but not necessarily with the correct control for that movement...the zoom in/zoom out actually zooms the camera and moves the head left or right, the joystick control can move the camera up and down, but left and right doesn't work properly...

 

 

does anyone have any experience with a problem like this?

1035686241_typicalsystemconnections.JPG.92c04c01c0d502050e7c659443c15649.JPG

Share this post


Link to post
Share on other sites

It sounds like the wires are crossed between the receiver and the pan/tilt head. Perhaps the pre-wired cable has been messed with.

Share this post


Link to post
Share on other sites

Up-the-Coax control systems tend to get skittish when not properly terminated. Check and make sure 75 ohm termination is on at monitoring end. Also, how long is the coax cable run between the controller and receiver? Try it with a short, known good cable, if you can.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×