kyrotech 0 Posted January 26, 2009 Hi, I hope someone could shed some light on the following issue I am currently using GV 8.2 with GV-650-8 I want to have my camera 1 setup to trigger output 1 whenever motion is detected. My output is a light (5000w), here is the problem, since its dark with only some street lights. I want the camera to record when someone/something enters a specific zone. so far so good, but a night time, the change of light causes the system to loop. So now my light goes on for 30 seconds, then off for 1 second, then back on because of the scene/motion detection. Here is my question, can we put a delay somewhere to prevent this? Share this post Link to post Share on other sites
