SambaNoodles 0 Posted March 3, 2009 Hi. I'm using v8.2 of Geovision. I connect remotely to the server via Internet explorer, and using a netbook running XP. Unfortunately, the max resolution on my netbook is 1024X600, but remote MultiView (allowing me to view multiple cams simultaenously) will not work at anything less that 1024*768. Therefore, since I'm stuck with viewing one cam at a time, is there a way to set it so that it shows each different cam on a rotating basis (cam1 for 2 seconds, then cam2 for 2 seconds, then cam3 for 2 seconds...etc)? By the way, does this resolution restriction also apply when viewing remotely using GeoVision's own standard RemoteView application? Thanks, Share this post Link to post Share on other sites
dcam 0 Posted March 3, 2009 Try this ... Control panel > Display settings > Advanced > Monitor > Uncheck box " Hide modes that this monitor cannot display". Note the warning , but don't put it any higher than 1024x768 Share this post Link to post Share on other sites
SambaNoodles 0 Posted March 3, 2009 Try this ... Control panel > Display settings > Advanced > Monitor > Uncheck box " Hide modes that this monitor cannot display".Note the warning , but don't put it any higher than 1024x768 Hi. That works, but I don't like the warning message that might damage the hardware of my brand new netbook. I would be equally as happy if I could just scan through all the cameras, (one at a time, for a few seconds at a time). Anybody know if this is possible? Share this post Link to post Share on other sites
