dudu_georgescu 0 Posted March 23, 2009 Hi, I am using the a pair of the following balun: Muxlab 50032 (http://www.muxlab.com/assets/files/datasheets/VE_Quad_Video_Balun.pdf) to run 4 video signals through the same cat 5e cable (Belden cable). Unfortunately I am getting some signal interference (i.e. waves on the screen of the four cameras) significant enough to trigger the motion detection of the DVR each couple of seconds. If I disconnect any three cameras, then the remaining one works properly, no interference. My questions would be: (i) is this interference normal (because if that is the case, I would have no choice but run more cables and I hate drilling holes in-between floors) (ii) could it be a problem with the cable (good quality, Belden fast-cat 5e, rated for 350MHZ, works with no problem if I only use it for one camera) (iii) could it be a faulty balun (No shielding in between signals) (iv) could it be some static, and if I discharge it somehow, then everything would work fine (iv) some other thing Any kind of help would be greatly appreciated. George Share this post Link to post Share on other sites