rvicker 0 Posted April 21, 2009 OK. It's been a while since I have had to do any serious configuration changes on a Geovision 8.2 system. This system has 16 cameras and no has a GV-IO USB attached. The IO has now been connected to an alarm system. Where I have fallen fuzzy on is setting up the schedule. I have 7 of the cameras (outside) each set to record motion, the others (inside) are set to record motion, invoke alerts and trigger a relay that sets off the alarm system. I have an input that is controlled by the alarm system being disarmed setup to Deactivate Notifications and the relay. I also have another input setup for when the alarm system has been tripped and to invoke alerts. The inside cameras, on motion, trigger the alarm if it is enabled, if the alarm goes off it triggers the alarm input of the IO. I want the system to record motion 24x7, but only send email/pager alerts when the input says the alarm system has been tripped. I would also like it to include a camera picture with the email when the alarm is tripped especially if the root cause is motion detect. If I setup a schedule that is Record, Motion Detect, Pager/Email, and Output with a 24x7 time frame will it work as I want or will there be emails while the alarm is disabled? Thanks. Share this post Link to post Share on other sites
