Jump to content
ramshift

Need Power supply Supercurcuit DMR9

Recommended Posts

I need a power supply wall adapter for Supercurcuit DMR9 It was missing when i bought it. I could make one if I knew the voltage and the pin out.

The jack in rear has 8 pin holes. Is it only 2 are actually used? Why so many pins? Chassie is also marked AVTECH 777M. If only 2 pins are used then I will remove the PC board and re-wire a 2 pin jack, but i still need correct voltage/amp

Share this post


Link to post
Share on other sites

POWER SUPPLY (DVR)

 

Do you have a DMR1 which is a 16 channel DVR, or do you have the DMR9 which is the 9 channel DVR?

 

AVC 777 is a 16 channel DVR part number. AVTech is the manufacture of your DVR.

 

http://scorpiontheater.com/cpcamtechsupport.aspx

http://scorpiontheater.com/troubleshooting.aspx

 

 

POWER SUPPLY

12 Volt 3 Amp.....5 Volt 6 Amp

 

Jentec......Model JTA 0409.....Jentec Spec Sheet..... http://scorpiontheater.com/Documents/AVTech_Guide_Jentec_JTA0409_Power_Supply_8pin.pdf

 

KDM.........Model KY 05072.... http://kdmpower.com/DVR572.html ...(8 Pin)

Leadman..Model KY 05072.... http://www.leadman.com.tw/Adapter/KY-05072.pdf .....Note this shows 4 pins (computer)

 

 

This is for the pin out of the power supply plug.

 

 

 

1. Gnd

2. Gnd

3. Gnd

4. +12

5. Gnd

6. +12

7. +5

8. +5

 

 

Here is more info for other AVTech DVRs

http://scorpiontheater.com/repair.aspx

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×