metafizx 0 Posted August 31, 2009 hi, I have an NC-1600 IP camera that the video imager failed, but the rest of the camera is probably ok. of course I could just junk it and buy another one..just curious if I could fix it. Wondering if anyone has tried to connect another video board to this camera ? and has schematics or a wiring diagram available?? nc-1600 is also known under a bunch of rebrands.. VCenter, AVIP, etc. it's been a pretty good cheap IP camera worked for atleast 4 years. Share this post Link to post Share on other sites
ak357 0 Posted August 31, 2009 hi, I have an NC-1600 IP camera that the video imager failed, but the rest of the camera is probably ok. of course I could just junk it and buy another one..just curious if I could fix it. Wondering if anyone has tried to connect another video board to this camera ? and has schematics or a wiring diagram available?? nc-1600 is also known under a bunch of rebrands.. VCenter, AVIP, etc. it's been a pretty good cheap IP camera worked for atleast 4 years. done it before open camera inside most likely 2 pcb's camera and ip server if u lucky red, black and yellow or white what u need between cam and ip server start to measure voltages or scope if u have or post here pix of inside of camera good luck Share this post Link to post Share on other sites
metafizx 0 Posted August 31, 2009 hi, there are 2 connectors. one goes to the IP server board, the other goes to a small daughter board for AGC/BLC/AI control. 1. 4 pin - black, yellow, black, red 2. 3 pin - 1 green, 1 red, 1 blue perhaps the 4 pin connector is video, power and the black wires are GND ? looking around for a similar video board. Share this post Link to post Share on other sites
ak357 0 Posted August 31, 2009 hi, there are 2 connectors. one goes to the IP server board, the other goes to a small daughter board for AGC/BLC/AI control. 1. 4 pin - black, yellow, black, red 2. 3 pin - 1 green, 1 red, 1 blue perhaps the 4 pin connector is video, power and the black wires are GND ? looking around for a similar video board. Ok take any reg cam u have and connect BNC video out to Yel and Blk from IP server (black being your ground) I bet u would have video using your IP cam soft good luck p.s. if its works for you then think now u have IP server which u can use with any camera in your stock Share this post Link to post Share on other sites
metafizx 0 Posted August 31, 2009 cool, I will try that and see if it works. thanks! Share this post Link to post Share on other sites
