autoadjustment with bandwidth in software under running.

[monostump 0]

In the new upgrade there is a possibility to change bandwidth in schedule for each camera.

 

If i have one camera that is on motiondetect on nighttime in full resolution.

Daytime i want to put the camera in lowest bandwidth when there is no need to have any records at all.

 

Are u with me?

 

If i putin the lowest bandwidth on each camera in the camerasetup and then put up to highest in schedule under motiondetect? Is this possible?

 

Or should i create a schedule daytime in motiondetect mode with the lowest bandwidth on each camera? And "blank" the picture that there is no possibility for the software to feel motion in picture?

 

In my minds i could have the motionevent in schedule that needs an external source to start the record. But this is not possible without cards that could handle external inputs? I only have IP-cameras and no camera at all directly to the NVR.

 

Nighttime: in motiondetectmode and record with enough quality and bandwidth for each camera.

 

Daytime: I really just need a connection between the camera and the NVR.

 

I really hope for positive answers and a good solution