KhaKha 0 Posted December 17, 2009 I'm new and beginner in this networking areas, I've just recently installed cameras in my home, I followed the manual to enable internet access from this forum, it worked only in my local network (computers connected to my wifi routers) while when I tried to connect via other computers outside my local network, it always RTO Is there any possible solution for my problems? Thank you Share this post Link to post Share on other sites
scorpion 0 Posted December 23, 2009 You have not provided a lot of info. Have you port forwarded your router? Have you verified your WAN ip address with www.ipchicken.com? Perhaps one of these manuals can make it simple for you? http://scorpiontheater.com/videonetworkingwithavtech.aspx Do you have the older version with the IDE, or the newer SATA hard drive? Share this post Link to post Share on other sites