Angus 0 Posted February 13, 2010 Hello, i have a question, i recently received a Bosch nwd 495, reading the spec sheet it says that it has bnc out, however it seems that it only has a 2.5mm monitor adapter which i would need the cable for.. So i guess the question is.. where can i get such a cable? And will it be full resolution? As right now i dont have a NVR so the IP portion isn't exactly what i'm after as id rather run the bnc into my dvr Thanks! Specs here http://resource.boschsecurity.com/documents/NWD495FlexiDome_DataSheet_enUS_T3861298059.pdf Share this post Link to post Share on other sites
Soundy 1 Posted February 13, 2010 That spec sheet says nothing about a BNC ouptut, it lists only the 2.5mm jack. You could probably find something at Radio Shack or an electronic parts store for it, or hack the wire off a phone headset that uses that type of plug, and put a new connector on the other end. The only mentions of the service output, however, are "The analog video service output and the on-screen displays (OSD) simplify focus adjustment and network configuration" and "Network parameters and basic camera set-up, such as lens set-up and back focus, are quickly and easily performed using the on-screen displays (OSD) and analog video service output." I'm not familiar with this camera specifically, but based on other IP cameras I've seen that have a similar output, it may have focus aids overlaid on the image, or may only work temporarily (some will shut off after a few minutes)... plus, the jack is typically inside the dome, so you may not be able to leave the wire connected once you close the camera. Share this post Link to post Share on other sites
Biphase 0 Posted March 30, 2010 Bosch makes the service cable: Part # S1460 ....or you could try to make your own..lol Share this post Link to post Share on other sites
