farra 0 Posted June 21, 2010 Hi all, For the last couple of days I have been trying to reset my DS2 admin/installer password as I don't remember it. It is Sprite 2 with 9 channels, however only 2 cameras have been setup. For any additional PTZ I will need admin password. I have read through the forum and contacted some members, followed the advice given (telnet, hyperterminal (didn't connect), 613126, hooked up the HDD to the PC) but all failed. Only at the end I realised my system board was M2IP which has a flash ram with the Operating system stored in it. HDD contained some logs, CDview and recorded video. Could anyone advise me on how to remove/reset the passwor for my dvr. I could see the jumpers 1-4, if i short anyone of them would I be able reinstall the sofware and IP? Thanks, Share this post Link to post Share on other sites
Sp00ky 0 Posted December 10, 2012 Hi there, just out interest (and i know this is a 2 year old post) but did you get this sorted? I have just bought the M2IP model and need to reset the passwords as well Share this post Link to post Share on other sites
