mike9313 0 Posted July 19, 2010 Hello, I have a 4-channel GE StoreSafe pro II running ver. 6.2. The unit was stored for about 1 ½ years and was recently powered up. I cannot access the menu with the default password 4111 and the date is showing 1/1/1960. The password was never changed while in use. The battery was dead so I replaced it. What are the procedures to restore the unit to the default settings? I did find some valuable links within this forum to the downloader software and firmware. Downloader is installed on my PC, but I need a valid IP address to the StoreSafe. I connected the StoreSafe to my router and then accessed my router to see if I could determine the IP address, but no such luck. I believe the network is disabled on StoreSafe. Share this post Link to post Share on other sites
gniroland 0 Posted August 18, 2011 4111 is the password used to make the DVR reset to default settings. Try using 3444 to gain full menu access. ~Roland Share this post Link to post Share on other sites
CCTV_Suppliers 0 Posted August 20, 2011 Here is the manual - http://utcfssecurityproducts.com/Site%20Assets/0150-0295B%20GE%20Security%20StoreSafe%20Pro%20User%20Manual.pdf Share this post Link to post Share on other sites
