Han02aa 0 Posted November 29, 2010 Dear All, I have a problem with a Vitek PTZ10 Analog Camera , i was operating on the Camera and while i was using the Zooming Function the Camera Address Switched From 0001 to 3201 ( even though the physical address on the camera on the Camera is 0001) and if change the Physical Address of the camera it changes only the last 2 digits and keep the first 2 Example ( physical address is 0003 , it shows the address to be 3203), now i can't control the camera through the DVR and the camera is stuck on maximum zoom . Does anyone has a solution to this problem ? Share this post Link to post Share on other sites
tomcctv 190 Posted November 29, 2010 Dear All, I have a problem with a Vitek PTZ10 Analog Camera , i was operating on the Camera and while i was using the Zooming Function the Camera Address Switched From 0001 to 3201 ( even though the physical address on the camera on the Camera is 0001) and if change the Physical Address of the camera it changes only the last 2 digits and keep the first 2 Example ( physical address is 0003 , it shows the address to be 3203), now i can't control the camera through the DVR and the camera is stuck on maximum zoom . Does anyone has a solution to this problem ? what make is your dvr and how do you have the ptz connected. Share this post Link to post Share on other sites
Han02aa 0 Posted November 29, 2010 THE DVR is A VITEK E16 DVR and the PTZ Controls are conected to it Share this post Link to post Share on other sites
Han02aa 0 Posted December 5, 2010 Come on People o really need some help with this problem ? is there any solution to this kind of problem ? Share this post Link to post Share on other sites
bpzle 0 Posted December 5, 2010 http://www.vitekcctv.com/Support.asp Share this post Link to post Share on other sites
Han02aa 0 Posted December 5, 2010 I did contact them but i didn't have any solution to this problem Share this post Link to post Share on other sites
SEANHAWG 1 Posted December 27, 2010 Why not change the dome ID on your Vitek DVR to 3201? Share this post Link to post Share on other sites
survtech 0 Posted December 27, 2010 Have you tried rebooting it (remove power for ~5 seconds)? Share this post Link to post Share on other sites
Han02aa 0 Posted December 27, 2010 @nelly i tried changing the ID but the maximum id is 99 which changes only the last 2 numbers Also i tried rebooting and waiting for 5 seconds nothing happens . i need to restore the camera into its factory defaults and there is no reset button :S Share this post Link to post Share on other sites
tomcctv 190 Posted December 27, 2010 @nelly i tried changing the ID but the maximum id is 99 which changes only the last 2 numbers Also i tried rebooting and waiting for 5 seconds nothing happens . i need to restore the camera into its factory defaults and there is no reset button :S Hi if you need to reboot to factory settings then you will need to connect your ptz to a controller to entre reset (it cant be done from your dvr) Share this post Link to post Share on other sites
