Jump to content
Sign in to follow this  
deploy

Alarm Block Security DVR Help. (Lorex)

Recommended Posts

I just got a Lorex 8 channel DVR. I am using continuous recording however, I would like to utilize the alarm block on the back of the DVR to trigger events, and send out email notifications.

 

 

I know very little about alarm wiring and was wondering if anyone could help me understand how to wire this.

 

The goal is to wire two motion detectors to the DVR and have them trigger a bell/siren

I will also have it send an email configured via the software.

 

 

The back of the panel as an alarm block that reads:

 

D+ D- G NO COM NC G1 14 3 12 11

 

 

The specification of the unit are listed as:

 

Alarm IN 4 x TTL, programmable as NC/NO

Alarm Out 1 x Relay with NO/NC contact

PTZ control By Terminal connector (RS485) Bookmark Archiving Supported

ConneCtIvIty

 

 

 

 

I have attached an diagram of the back. How would I go about wiring this. I am not sure what each letter mean. I understand NO and NC, I assume D+ and D- and 12V+ and 12V- and G is ground ?

1535892828_Picture4.png.2d938dcd924ab3da5dc8f402c9371d8f.png

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×