Maniek 0 Posted December 4, 2011 Hello everyone. I'm going to install 2x AV8185 cameras and few SONY snc-ch120 at one of my customer's site. Cameras are on test by me at the moment. Problem is, I can't align areconts to be at one line, like one common picture. On AV 100 software, alignment is enable and it is nearly good ( not perfect), settings saved to flash. On Milestone it is not what I expect. Is there any solution for it? Milestone Prof. Thank you in advance. Regards Mariusz Share this post Link to post Share on other sites
hardwired 0 Posted December 4, 2011 Try going into the camera settings and adjust the starting pixel position on the #3 image (rather than starting at 0, try a hundred or so pixels as the starting vertical position). That should digitally crop the image and move it up in relation to the others. Then you can fine tune the cropping between each image as needed. *********Edit******* Also check if you have "maintain image aspect ratio" either checked or unchecked on all of the cameras, it looks like some are set that way and some are not. Share this post Link to post Share on other sites
