Qvis 4 Channel DVR - Monitor and Spot

[lselfstorage 0]

Hello,

 

I'm in the process of changing out a unit with a recently purchased 4 channel Qvis unit...the unit that's being replaced has two monitors connected to it:

 

Monitor 1: 4 Channel Grid View

Monitor 2: Rotates between all 4 cameras...

 

How do I connect these two monitors to the Qvis/Dahua to accomplish the same task? I have one connected via VGA, and the other via BNC but they display the same image on both...

 

thanks

[Birdman Adam 0]

Yep, thats how it works with my Qvis.

 

What you do is go into Display, and enable a Tour, say 1 view (one camera shown on screen at a time), and cycle between all every 5 seconds.

 

I have done similar, with motion set up to bring the camera up on 8-view, one enlarged. Then the normal tour function brings it back to 9-view after 6 seconds.

[lselfstorage 0]

Is that "tour" occuring on one screen while the other screen shows the 4 view grid? Or are you saying that the Qvis device cannot use a second monitor to perform that task?

 

Thanks

[joseph.chen0312 0]

Is that "tour" occuring on one screen while the other screen shows the 4 view grid? Or are you saying that the Qvis device cannot use a second monitor to perform that task?

 

Thanks

 

Hi it is normaly design two output for one is main to remote and control and spot is only to monitoring watch.